Alloy stick motor mount. (to suit 10mm wide stick)
Made from alloy the mount is very light yet still strong.
Mount dimensions are 30x20mm, suits 10mm sticks and has motor mount hole dimension of 19mm and 22mm.
Perfect for most small brushless motors.
Because the stick bracket is a clamp system, a variety of stick sizes can be used.
23/09/2009 Helgeo (60%)
Will a 36 mm motor fit on this? Would like to see a stick mount for larger motors.
vasy1
(56%)
I made it fit, just had to drill 2 holes. DONT use it for sure! It is a little soft and 36mm motor applies so much power it bends and eventually brakes off, I had a motor take a flight away from the plane in mid air :( The listed motor sizes are perfect as they don't stress the mount enough* I used them with perfect success.
ironside
(44%)
hi there! this is a great mount for smaller planes, i can now use an outrunner which is far more efficien compaired to a geared motor. there is also much less repaing by going to a brushless thanks jim
All hobbyKing.com® content is copyright 1999 - 2010 by hobbyKing.com® and hexTronik Ltd. except where otherwise indicated.
The hobbyKing.com® logo and name are both trademarks of hexTronik Limited.
.jpg)
