|
|
|
|
| great battery, great quality, great price, I use it a RC18b with a 6800kv mamba motor and 25 amp esc, with 14/55 gearing.delivers a great punch and top speed, only gets slightly warm. the only thing is its size is listed wrong its 85x35x17 no big deal tho.
11 people like this review.
|
|
|
| Nice battery, runs on 10C no hot in small boat. Thx hobbycity
6 people like this review.
|
|
|
| Very nice batt with good price, zippy quality, they perform very good in my Robbe Gemini Flyng boat, more than 10 minuts flying time. :)
4 people like this review.
|
|
|
| I use this in my Guru-Z belt drive 300 series CP helicopter and it holds 10.6V when pulling 11A static. an awesome pack for 300 class CP microheli's!
3 people like this review.
|
|
|
| I use this LiPo in 4 of my TX, which are build for 8 AA cells. I had to modify the compartment by cutting space for the battery. I use JST instead of the Deans. The balance connector is located on the outside via the edge of the lid. I always charge the LiPo with the JST-XH connector. I also bought a JST-XH Wire Extension 3S (20cm) as a charge/balance cord. If you whant to be on the safe side you can charge by taking the battery out. I don't.
3 people like this review.
|
|
|
Verwende 3S im MPX Parkmaster mit 10x4,7SF und
Turnigy 2213 20turn 1050kv 19A .
Gent sehr gut Senkrecht, Hoovern kein problem.
3 people like this review.
|
|
|
These batteries are great, the weight is nice for its specifications.
I flew it with a Honeybee FP helicopter, the wires are probably bit too thick, but it makes it safer. I fly about 15 mins with this great battery. It dont even gets hot!
These batteries are great!
3 people like this review.
|
|
|
Two of these LiPo pack's just arrived today. I measured voltage cell by cell and the results are:
pack1: cell1-3,92V cell2-3,92V cell3-3,92V
pack2: cell1-3,93V cell2-3,93V cell3-3,93V
So these pack came perfectly balanced!
2 people like this review.
|
|
|
| I love theese batterys. Low cost and they give enough power for my 350g Delta with FC 28-05 outrunner and APC 4.1x4.1 for vertikal climb.
2 people like this review.
|
|
|
Very nice batt with good price. I bought 2 pieces.
Both packages have 25 of charge cycles and everything is ok.
2 people like this review.
|
|
|
Ich benutze den Akku in einem Art-tech Falcon 3D. Passt genau so gut wie der Originalakku in die Akkuhalterung.
Er bring eine bessere Leistung als der Original Akku von Art-tech.
Dieser Akku ist einfach nur zu empfehlen.
Damit den Lipo-Akkus ein langes Leben beschieden ist, sollte man sie nur mit maximal 75% des erlaubten Maximalstromes betreiben.
Hier also mit maximal 15C anstelle der aufgedruckten 20C.
2 people like this review.
|
|
|
| Great lipo.. flew it with my Parkmaster.. Plenty of power!
1 people like this review.
|
|
|
Muy buena bateria !
Compre una y llego perfectamente balanceada. En su primer vuelo anduvo muyyy bien.
1 people like this review.
|
|
|
| I am using these on my OMP Yak Stiffy V2. It is powered by a Hacker A20-20L with a 11x5.5 prop. This setup pulls 24 amps WOT, and these batteries have no problem providing so much juice. They come down just a bit warm every flight. Also, the listed weight is very accurate, with my batteries weighing about 115 grams each. I am going to buy a couple more to increase my flight times.
1 people like this review.
|
|
|
| I use in a Tzagi Toro 900 with a 8x6 and a 1400 kv brushless Himodel, 21 A. Excellent.
1 people like this review.
|
|
|
| batteries with a fantastic price and very good speed of delivery here in Brazil in less than 15 days were in my house .... I'm super happy with the batteries of the Rhino and recommend to all my friends and visitors from hobbycity |
|
|
| Muy buen producto, de alta calidad, 100% r |
|
|
Nice battery. Even discharge.
Slightly warm when used.
|
|
|
Ich benutze den Akku in einem Art-tech Falcon 3D. Passt genau so gut wie der Originalakku in die Akkuhalterung.
Er bring eine bessere Leistung als der Original Akku von Art-tech.
Dieser Akku ist einfach nur zu empfehlen.
Damit den Lipo-Akkus ein langes Leben beschieden ist, sollte man sie nur mit maximal 75% des erlaubten Maximalstromes betreiben.
Hier also mit maximal 15C anstelle der aufgedruckten 20C. |
|
|
| I've been running these in my Park master 3D and it's great! No bloating what-so-ever. Highly recommended! |
| Click here to see all reviews |
5 crowns 
